1. Home
  2. Honda R&D Technical Review Vol.15 N...
  3. Method of Controlling Arc Welding o...

Technical Review e-Book: Summary

Method of Controlling Arc Welding on Ultrathin Board

Article of Honda R&D Technical Review Vol.15 No.1

Summary

A positive proportional relation between arc length and arc illumination was found to apply in arc welding. By applying this relation, a control technology was developed that maintains arc length at a constant fixed value during welding. This enabled control that is able to maintain a fixed arc length of 1.0 mm or less, which was not possible with conventional arc voltage control. As a result, stable, uniform melting was achieved on ultrathin boards 0.5 mm thick or less by the application of low-current, low-voltage welding.

Author (organization or company)

Koji UEDA(Tochigi R&D Center)、Akira YANAGITA(Tochigi R&D Center)、Takeshi YAMAGAMI(Tochigi R&D Center)、Manabu MURAKAMI(Tochigi R&D Center)

We would like to get your opinion on this research paper. (This is only applicable to registered members.)

The readers of this research paper have also selected these research papers.

Research on Automatic Inspection of Spot Welding Using Ultrasonic Testing Methods
Article of Honda R&D Technical Review Vol.18 No.2
Development of Resistance Spot Welding Simulation Technology
Article of Honda R&D Technical Review Vol.18 No.1
Development of an Engine with 3-speed Automatic Transmission for “TRX650FA”
Article of Honda R&D Technical Review Vol.15 No.1