1. Home
  2. Honda R&D Technical Review Vol.18 N...
  3. Development of Technology to Create...

Technical Review e-Book: Summary

Development of Technology to Create Surfaces with High-speed from Measurement Data

Article of Honda R&D Technical Review Vol.18 No.1

Summary

Transformation of measurement data from parts into CAD models allows the data to be more widely used in the automotive development process. Surfaces are formulated from the data and fed back into the CAD model. These surfaces must correlate well with a low degree of error against the measurement data.
However, creating these surfaces requires considerable data processing time. A new algorithm for surface creation that combines high accuracy with high-speed processing has therefore been developed. This has resulted in a 90% reduction in the time required for surface creation with no significant increase in error.

Author (organization or company)

Ryutaro HARADA(Tochigi R&D Center)、Yoichiro ISHIHAMA(Tochigi R&D Center)、Yuuji FUSE(Tochigi R&D Center)、Kinya FUJIWARA(Tochigi R&D Center)、Takanao UCHIDA(Tochigi R&D Center)

We would like to get your opinion on this research paper. (This is only applicable to registered members.)

The readers of this research paper have also selected these research papers.

Friction Analysis by Piston Secondary Motion Simulation in Consideration of Cylinder Block Bore Distortion
Article of Honda R&D Technical Review Vol.18 No.1
Development of Resistance Spot Welding Simulation Technology
Article of Honda R&D Technical Review Vol.18 No.1
Styling Design of New CR-V
Article of Honda R&D Technical Review Vol.24 No.2