1. Home
  2. Technical Review Vol.28 No.1 has been released.
ISSN 2187-381X

Technical Review e-Book News Release

Mar 31, 2016

Technical Review Vol.28 No.1 has been released.

Honda R&D Technical Review Vol.28 No.1

◆Introduction of new technologies
-Development of New Fuel Cell Vehicle CLARITY FUEL CELL
-Development of In-tank Solenoid Valve Compatible with 70 MPa High-pressure Hydrogen Storage and Supply System for FCV
-Development of CCM Water Content Distribution Measurement System for Fuel Cell Stack
-Numerical Prediction of Water Content Distribution of Catalyst Coated Membrane of Fuel Cell Stack using Simulation
-Real-time Measurement of Water Content of CCM in On-board Fuel Cell Stack System
◆Technical papers
-Empirical Model for Polymer Electrolyte Fuel Cell Electrocatalyst Degradation Using Platinum Stress
-Life Prediction Model Estimating Chemical Degradation of Polymer Electrolyte Membrane for Fuel Cells
-Life Prediction Technology of Fuel Cell Polymer Electrolyte Membrane under Mechanical Degradation
-A Pore-Scale Multiphysics Method to Study PEMFC Catalyst Layers
-Three Dimensional Large Scale Numerical Simulation of PEMFC with Low-Pt Loading
-Development of 70 MPa Differential-pressure Water Electrolysis Stack
◆Introduction of new technologies
-Design of Next-generation Environmental Vehicle CLARITY FUEL CELL, realizing Harmony between Vehicles and Society
-Styling Design of the Forza125
-Styling Design of New Tact, 50 cc Standard Scooter
-Development of RC213V-S
-New In-Line 4-Cylinder Gasoline Direct Injection Turbocharged Downsizing Engine
-6-Speed Manual Transmission for Honda S660
-Accurate Capacity Estimation and Forecast of Li-ion Battery for BEV Using Telematics
-Development of Vehicle System Supporting Vehicle-Grid Integration
-Nonlinear Finite Element Method Solver for Design of Automotive Cable Layout
-Introduction of Heat Exchanger Production Technique for Stirling Engine Using Additive Manufacturing
◆Technical papers
-Stir-casting Process and Mechanical Properties of Forged Mg-Zn-Y Alloys for Piston
-Prediction of Fracture of Cylinder Block Main Bearing by Fretting Fatigue and Development of Verification Method

Honda R&D Technical Review Vol.28 No.1